The operating system cannot be located on drive A or drive C. The system configuration information in the system setup program is incorrect or the battery charge may be low. One possible beep code code consists of one beep, a burst of three beeps, and then one beep. Memory modules are detected, but a memory configuration or compatibility error exists. See “Contacting Dell” in your Owner’s Manual for instructions on obtaining technical assistance. If the computer malfunctions, the color and sequence of the lights identify the problem.
|Date Added:||16 September 2012|
|File Size:||25.20 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Error in the DMA controller on the system board. Ensure that nothing is resting on the keyboard; if a key appears to be stuck, carefully pry it up. Ensure that the drive is installed correctly in the computer and defined correctly in the system setup program. Verify that the memory modules that vidro are installing are compatible with your computer.
An error in the address decoding circuitry in the memory has occurred. This series of beeps, called a beep code, identifies a problem. If available, install properly working memory of the same type into your computer. See “Contacting Dell” in your Owner’s Manual for instructions on obtaining technical vieo. Search for video ROM failure. To help you troubleshoot a problem, your computer is equipped with four lights on the back panel labeled “A,” “B,” “C,” and “D.
To continue using , please upgrade your browser.
Memory not being properly identified or used. Video Memory Test failure. If the computer starts normally, troubleshoot the last card removed from the computer for resource conflicts see “Resolving Software and Hardware Incompatibilities” in your Owner’s Manual.
The hard drive is not working or is not configured correctly. Interrupt vector loading failure.
Slave DMA register failure. Check the interface cable at both ends. The computer is in a normal operating condition after POST.
Panasonic WJ-4600C Special Effects Generator
Ensure that the cables are properly connected from the hard drive, CD drive, and DVD drive to the system board. Timer-chip counter 2 failure.
If the computer starts normally, troubleshoot the last card removed from the computer for resource conflicts see “Resolving Software and Hardware Incompatibilities” in the Owner’s Manual.
Determine if a conflict exists by removing a card and then restarting the computer. To eliminate the possibility of vireo faulty memory connector, remove all memory modulesreinstall one memory module if the computer supports a single moduleand then restart the computer.
An interrupt channel on the system board failed to POST.
Dell Dimension – Wikipedia
An error occurred with the keyboard connector. The computer is in a normal off condition or a possible pre-BIOS failure has occurred.
Enter the system setup program and confirm that drive A or drive C is properly identified. If the problem persists or the computer has integrated video, see “Contacting Dell” in your Owner’s Manual. Repeat this process for each card. Master DMA register failure.
If the problem persists, reinstall the card that you removed, remove a different card, and then restart the computer. Reinstall all memory modules and restart the computer. If the computer starts normally, move the memory module to a different connector and restart the computer.
Reinstall all USB devices, check cable connections, and then restart the computer. Strike F1 to retry reboot, F2 for setup utility.